- 您现在的位置：买卖IC网 > Sheet目录222 > DS1993L-F5+ (Maxim Integrated)IBUTTON MEMORY 4KBit F5
DS1992/DS1993
MEMORY
The memory map in Figure 4 shows a 32-Byte page called the scratchpad, and additional 32-Byte pages
called memory. The DS1992 contains pages 0 though 3 that make up the 1024-bit SRAM. The DS1993
contain pages 0 through 15 that make up the 4096-bit SRAM.
The scratchpad is an additional page that acts as a buffer when writing to memory. Data is first written to
the scratchpad where it can be read back. After the data has been verified, a copy scratchpad command
transfers the data to memory. This process ensures data integrity when modifying the memory.
MEMORY FUNCTION COMMANDS
The Memory Function Flow Chart (Figure 6) describes the protocols necessary for accessing the memory.
An example follows the flow chart. Three address registers are provided as shown in Figure 5. The first
two registers represent a 16-bit target address (TA1, TA2). The third register is the ending offset/data
status byte (E/S).
The target address points to a unique Byte location in memory. The first 5 bits of the target address
(T4:T0) represent the Byte offset within a page. This Byte offset points to one of 32 possible Byte
locations within a given page. For instance, 00000b points to the first Byte of a page where as 11111b
would point to the last Byte of a page.
The third register (E/S) is a read only register. The first 5 bits (E4: E0) of this register are called the
ending offset. The ending offset is a Byte offset within a page (1 of 32 Bytes). Bit 5 (PF) is the partial
Byte flag. Bit 6 (OF) is the overflow flag. Bit 7 (AA) is the authorization accepted flag.
Figure 5. ADDRESS REGISTERS
7
6
5
4
3
2
1
0
TARGET ADDRESS (TA1)
TARGET ADDRESS (TA2)
T7
T15
T6
T14
T5
T13
T4
T12
T3
T11
T2
T10
T1
T9
T0
T8
ENDING ADDRESS WITH
DATA STATUS (E/S)
AA
OF
PF
E4
E3
E2
E1
E0
(READ ONLY)
Write Scratchpad Command [0Fh]
After issuing the write scratchpad command, the user must first provide the 2-Byte target address,
followed by the data to be written to the scratchpad. The data is written to the scratchpad starting at the
byte offset (T4:T0). The ending offset (E4:E0) is the Byte offset at which the host stops writing data. The
maximum ending offset is 11111b (31d). If the host attempts to write data past this maximum offset, the
overflow flag (OF) is set and the remaining data is ignored. If the user writes an incomplete Byte and an
overflow has not occurred, the partial Byte flag (PF) is set.
Read Scratchpad Command [AAh]
This command can be used to verify scratchpad data and target address. After issuing the read scratchpad
command, the user can begin reading. The first two Bytes are the target address. The next Byte is the
ending offset/data status Byte (E/S) followed by the scratchpad data beginning at the Byte offset (T4: T0).
The user can read data until the end of the scratchpad, after which the data read is all logic 1’s.
5 of 17
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
DS1995L-F5+
IBUTTON MEMORY 16KBit F5
DS1996L-F5+
IBUTTON MEMORY 64KBit F5
DS9092K#
KIT IBUTTON STARTER
DS9502P+T&R
DIODE ESD PROTECTION 6-TSOC
DS9503P+
DIODE ESD PROTECTION W/RES 6TSOC
DSL70 E6327
DIODES TVS ARRAY R-R SOT-143
DT-2R48-B6
SWITCH PLUNGER DPDT 10A SCREW
DT-2R722-A7
SWITCH PLUNGER DPDT 10A SCREW
相关代理商/技术参数
DS1993L-F5-C01
功能描述:iButton
RoHS:否 存储类型:SRAM 存储容量:512 B 组织: 工作电源电压:3 V to 5.25 V 接口类型:1-Wire 最大工作温度:+ 85 C 尺寸:17.35 mm x 5.89 mm 封装 / 箱体:F5 MicroCan 制造商:Maxim Integrated
DS1994
制造商:DALLAS 制造商全称:Dallas Semiconductor 功能描述:4kb Plus Time Memory iButton
DS1994-LF5
制造商: 功能描述: 制造商:undefined 功能描述:
DS1994L-F5
功能描述:iButton
RoHS:否 存储类型:SRAM 存储容量:512 B 组织: 工作电源电压:3 V to 5.25 V 接口类型:1-Wire 最大工作温度:+ 85 C 尺寸:17.35 mm x 5.89 mm 封装 / 箱体:F5 MicroCan 制造商:Maxim Integrated
DS1994L-F5+
功能描述:iButton RoHS:否 存储类型:SRAM 存储容量:512 B 组织: 工作电源电压:3 V to 5.25 V 接口类型:1-Wire 最大工作温度:+ 85 C 尺寸:17.35 mm x 5.89 mm 封装 / 箱体:F5 MicroCan 制造商:Maxim Integrated
DS1994L-F5-W
功能描述:iButton
RoHS:否 存储类型:SRAM 存储容量:512 B 组织: 工作电源电压:3 V to 5.25 V 接口类型:1-Wire 最大工作温度:+ 85 C 尺寸:17.35 mm x 5.89 mm 封装 / 箱体:F5 MicroCan 制造商:Maxim Integrated
DS1994-LFS
制造商: 功能描述: 制造商:undefined 功能描述:
DS1995
制造商:DALLAS 制造商全称:Dallas Semiconductor 功能描述:16-kbit Memory iButton